Now that’s a good looking gearbox!

The Audi 01E gearbox looked a bit ratty on the outside so I thought about soda blasting it then polishing it but finally decided that painting it was the way to go. Chose a colour as close to the Coyote engine block as I could and used a flat clear like you see on some new cars these days. I have to say that I am very happy with the result and it should look pretty flash in the engine bay.

High pressure clean and then sand any corrosion areas down and scothbrite all over…
Mask up the steel parts and any sensors etc…
Etch prime…
Then use a 2 pack primer and straight on with the colour wet on wet…
Then finish off with the flat clear coats…
Mask up the silver…
Spray the black gloss and untape… voila!